VÈRITAS

VÈRITAS can be used pure or diluted up to 1:5 . Pure to eliminate old protections or to solve problems during the application of a coating. Diluted 1:1 as a control in the spot test phase while diluted from 1:3 to 1:5 as a normal post-polishing check. In case of pure product, spray VÈRITAS on a microfibre cloth and then wipe the surface. In case of diluted product, spray it directly on the surface. Avoid dispensing the pure product directly on the bodywork. To check the health of the coating, after washing the car and with the car wet, spray VÈRITAS on the surface of the hood from a distance of 60 cm, then rinse with a jet of water. If used pure, spray the product on a short-haired microfiber cloth and then pass it over the affected area, taking care not to apply any pressure, preferring linear movements and then finish with the dry side of the cloth. If used diluted, spray the product on the affected area and then with a microfiber cloth without any pressure spread it on the surface, at the end finish the surface with the dry side of the microfiber cloth. Do not use VERITAS on hot surfaces or under sources of heat , in the presence of surfaces painted with a single layer direct gloss system, avoid drying the product on the surface.